My second print : let's try the support feature
By anar on 11/01/2011, 19:14 - Print - Permalink
I'd like to see how the Rapman is going to handle a more complex object with overhangs...
For that second print I choosed this 3D scan object because I like it :
After importing it in Axon, choosing good settings, and making the build, I put it on my SD card and bring into the Rapman for printing.
The support settings are the default ones.
The print completed successfully in about 6 hours.
And here is the result (sorry I've touched it too much so the print is a bit dirty...) :
Updated 30/01/2011
I have printed it again without any problem.
Here are both of them next to each other :
