29/03/2025
By Anar on 29/03/2025, 20:00
During the last 2 years I spent some time at customizing my small car, a Citroën AMI 100% electric.
I's a very minimalistic tiny car that can go as fast as 45 km/h with an autonomy of 70 km.
And here "minimalistic" means that there was place for a lot of improvements...
16/01/2022
By Anar on 16/01/2022, 17:12 - Weedo Tina2
In my previous post I introduced you to the Weedo Tina2 3D printer on which I allready performed a few improvements.
Among them I told you that I will probably add some light inside it. Because I'd like to be able to better see my models being printed in dark situations or at night time.
So let me show you how this can be done in this very easy to follow tutorial...
17/03/2017
By Anar on 17/03/2017, 19:36 - Print
Since a few years I have a legendary KORN & MACWAY SERVO-SOUND Cybernetic preamplifier with its 2 active speakers.
But unfortunately I only own one of the 2 proprietary cables so I'm unable to listen to it (or only on 1 of the 2 speakers).
And these cables are nearly impossible to find (I've been searching a lot and never found one).
So I decided to make another one by myself...
15/10/2013
By Anar on 15/10/2013, 13:28 - InMoov
Lors de nos premiers essais de motorisation de l'épaule gauche, Mad s'est rendu compte que les moteurs ne tournaient pas toujours à la même vitesse en fonction de la position des potentiomètres.
Il s'est alors dit qu'il y avait peut être quelque chose à faire avec çà et qu'il serait éventuellement envisageable de programmer des accélérations et des décélérations...
Il a donc embarqué l'épaule chez lui afin de procéder à des essais et voici ses conclusions.
07/10/2013
By Anar on 07/10/2013, 17:32 - InMoov
De son coté Gilou a mené ses propres tests avec le "doigt tutorial", une Arduino Uno et un Raspberry Pi.
Et voici ce qu'il m'a envoyé...
Merci Gilou !
28/01/2011
By anar on 28/01/2011, 15:43 - Spare parts
Unless you mounted the PCB fan on its wrong side (which you should better check twice - 99% of the Rapman I've seen have been built with both fans upside-down !), you are probably pissed off having it sucking the dust from your desk !
And I don't even speak about the generated noise.
Let's try to find a solution for that...
14/01/2011
By anar on 14/01/2011, 19:41 - Spare parts
Not only the extruder connector is unprotected.
The PCB itself has all the electronics visible...
13/01/2011
By anar on 13/01/2011, 18:36 - Spare parts
Let's have my Rapman print parts for itself !
